Epic Boards > Announcements

MDC Gauges replacement for 99 Model year

(1/3) > >>

Capt Rick:
Have done 3 kits this week for 99 model year boat when gauges stop working.

MGA0010911   MDC replacement, 1999 Instrument 7 Gauge Dash, replace w Analog Rick Cohn 10200 Newington drive Orlando, Fl 32836   10    2    $749.00    35.

Capt Rick:
Steps to removing MDC, gauges and wiring.

Battery switch off.
Remove 2 screw cap next to windshield, using short stub Phillips screwdriver remove 2 screws.
Remove 2 screws caps on bottom front and nuts w 3/8 wrench.
Remove stereo cover and back securing strap  slide stereo forward.

Tilt dash up a get a small box to hold up dash.
Remove the nuts with deep socket 5/16
Remove wire clip holding wires to each gauges. Push gauges out from back with twisting motion.
Remove 4 screws holding the Medallion MDC from under dash ( removing the fire extinguisher) and the kick board there are 4 Phillips screws holding it. Remove the speedometer Hoses cut at fitting.
Remove alarm wire at top. Remove the 6 pin plug and the 12 pin plug attached to MDC end of wiring harness.
ship to Rick Cohn 10200 Newington Drive Orlando Fl 32836
allow 1 week to process. questions 407-701-4430

Capt Rick:
Correction remove 6 + 9 Pins white connector Plus Connected to MDC.

Capt Rick:
Installing new gauges

Capt Rick:
The computer MDC is no longer available. This kit replaces all gauges with Analogue gauges with 2 year warranty.
 Capt. Rick
407-701-4430 

Navigation

[0] Message Index

[#] Next page