Accesory installation

[sxalberta]

I am installing heater and shower in my SX22,  does anyone know where the wires for powering the shower pump are located ?  in the maintenance section it indicated aft port but I can not find any wires ?  Where can I pull some power from and use the accessory switches in dash for atleast the shower.

thanks

[denver]

I have a shower installed in my boat, I will have it out later this week, if you dont get an answer before then Ill take some pictures. 

[sxalberta]

thanks

[wakejunky]

on my sx wire colors are brown with Green stripe and black. my wires are just bellow the spark arrestor. goes along the vdrive storage board and up and across the back of the engine near the fuses and ECM then goes behind the starboard vdrive locker front cover. it may be wrapped up inside that cover if you cant find it at the spark arrestor. Or they ran separate wires the whole way. there not in a loom just zip tied along others.

FYI  the factory partially precut the wall board directly behind the engine. if you feel on the engine side you can feel the cut outs and make your job much easier. whoever installed my shower just cut a hole and later i was trying to mount my coolant reservoir and of course where i wanted to mount it was where the shower box was suppose to go.......... the cut out is on the  starboard upper corner on my boat

[sxalberta]

Can not seem to locate any wires for the shower from the factory, any indication of where they are initially connected into harness would be helpful as well.

thanks again

[ktdust]

Wakejunky's description is pretty accurate for the location. There's also a wiring diagram for the accessory harness under the maintenance tab that will trace location and splices for wiring.