adding cleats?

[Kyle]

My ?99 X22 could definitely use a couple more cleats.  I was planning on adding one on each side towards the rear of the boat.  I was wondering if any of you have done this.  If so, I would appreciate some advice on which ones to get (pop-up, pull-up, etc..), where I can find them, and some installation tips.  Thanks.

[cyclone]

I can give you measurements of where mine are mounted, I would definitely use pop up cleats because they catch the rope if they are not pop ones. It only takes two holes to mount them, a no brainer

[Kyle]

The measurements of where yours are mounted would be a big help.  I was looking at installing some like this:
http://www.attwoodmarine.com/Products/parts.asp?ProductID=950&path=marine&category=6>ype=1&group=1&subgroup=0&categoryname=Marine+Hardware&typename=Cleat&headername=Marine+Hardware
Just out of curiosity, did Toyota start putting cleats towards the rear of these boats after my '99?

[cyclone]

I'm pretty sure that my dealer installed mine, which means I'm in for an unpleasant surprise when I measure from the bow eye to the cleats on each side. Not that the guy smokes a lot of dope, but it's enough. It's not critical where they are located, the cool stainless pop up ones are the ones you want. I couldn't follow the link, it's late and I'm tired. Put them where it makes sense to you, I.E. where you bump into the dock when you tie up.